Typically the panel box will be placed in the basement near the main electric panel for a wired alarm system. Location of power depends largely on where the panel is located. Any ideas has to a typical install of alarm system? Is the power outlet hidden somewhere? However, I don’t see any power outlets anywhere near the metal box. I see that power wires were not connected, but the power wire and adapter is inside the metal box, along with the backup battery. If this is a new build and a new system, the code is very likely already the default code. If needed, any way to reset to factory defaults to reset to factory codes? Doing a quick search, the system may require an installer’s code. Older V1 versions would not be compatible. Will this work with suretyDIY/? If so, which cellular module do I need to purchase?Īs long as it is a V2 it should work with the NX-400-US-VZ. Is there a way to add more key panels? Would be nice at the front door and the other garage entry door since two garage entry doors are located at the opposite ends of the house. There are only two key panels one in the master and one at the garage entry door.I see that power wires were not connected, but the power wire and adapter is inside the metal box, along with the backup battery.

Doing a quick search, the system may require an installer’s code.Will this work with suretyDIY/? If so, which cellular module do I need to purchase?.The managed to pick the lock to the cabinet and found that alarm board is a NetworX NX-6V2 and key panels look same as the Concord 4, but can’t be sure since there are no other marking on it other than “GE”. Checked all the doors and windows and all have sensors hardwired, but those are installed into only 5 zones. I am trying to use the builder installed alarm system with suretyDIY/ and needs some help/advice.

Networx alarm keypad